Crimp the IDC connectorĬrimp the ribbon cable to the IDC connector. The RX from the IDC header must be connected to the TX from the DB9 connector. Warning: The TX from the IDC header must be connected to the RX from the DB9 connector. Verify the pinout of the carrier board pin header and the serial DB9 connector. The image below presents the bill of materials required for the adapter: Note: you may use another cable type and length, depending on your preference Solder wire and soldering iron, depending on your DB9/D-sub connector.DB9/D-sub female connector (preferably a 10-pin IDC to 9-pin D-sub male connector).It is available in the Carrier Board Accessory Kit and from many electronic components suppliers, e.g. You may buy one adapter, paying attention to the standard - usually called DTK or Intel standard. ![]() ![]() The following steps will guide you through assembling your adapter cable. In order to connect the RS-232 from the Iris or Ixora carrier boards to a DB9 connector, you must assemble a 10-pin IDC to DB9 adapter.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |